Deuterium Lamp Power Supply

Deuterium Lamp Power Supply is used in UV Spectra Chromatography, Atomic Absorption, UV-Visible Spectrometers and other Spectroscopic equipment.
 
To ensure the stability of UV Spectra, the D2 Power Supply has a number of features including the use of high frequency mode, set filament preheat, high voltage trigger and constant current control. Mains input Voltage 85 - 265V AC, no switching is required, Heater Voltage 2.5V and 10V power supplies available.
Deuterium Lamp Power Supply will operate most D2 Lamps from all manufacturers, including Heraeus, Hamamatsu and Photron.

Deuterium Lamp Power Supply

Deuterium Lamp Power Supply Connection Diagram

 

Deuterium Lamp Power Supply 10 Volt D2PS10V

Input Voltage:  85 -265Vac
Input Current: Max. 0.5A
Filament voltage:Preheating: 10Vdc
Lit: 6-7Vdc
Anode Voltage: Preheating : 125Vdc
Lit: Max: 80Vdc
Anode Current: 300mA
Constant current Accuracy:0.05% (after 10min)
Ignition Voltage: 400Vdc
Dielectric strength: 1500V / 1min
Shutting Down Signal: 3 -12V / 1 mA
Operating Temperature: 0-40 C
Size: 130 x 100 x 40 mm

Deuterium Lamp Power Supply 2.5 Volt D2PS2.5V

Input Voltage:  85 -265Vac
Input Current: Max. 0.5A
Filament voltage:Preheating: 2.5Vdc
Lit: 0Vdc
Anode Voltage: Preheating : 115Vdc
Lit: Max: 80Vdc
Anode Current: 300mA
Constant current Accuracy:0.05% (after 10min)
Ignition Voltage: 400Vdc
Dielectric strength: 1500V / 1min
Shutting Down Signal: 3 -12V / 1 mA
Operating Temperature: 0-40 C
Size: 130 x 100 x 40 mm